VK001 Post-Si ValidationHW101x · silicon 1.0
Dashboard / I2C

I2C

1 test case · I2C · silicon 1.0 · generated 02-Nov-2026 14:11:07

PASS 1
No priority set1 of 1 passed · 0 not passed
Bench time (estimates)
TestsExecution (min – max)Setup (min – max)Total (min – max)Estimated
All tests1tbd-tbd0 of 1 tests
Not passed0---0 of 0 tests
Feature coverage · 1 features · 1 verified · 0 failing · 0 open
FeatureCovered byFeature status
Register Read Write
0001
PASS

Test cases

1 of 1 shown
Priority
Status
Test caseName and test descriptionPriorityOwnerStatusLast runRun mode · setup · execution
TC_I2C_0001
I2C_REG_RW
  • I2C register read/write validation is executed from firmware
  • Default register values are verified after reset
  • Pattern testing is performed on CR, SR, AR, DR, ISR, TSR
  • Random data write/read is performed on all registers
  • Byte, half-word, and word accesses are validated
  • Invalid address access is tested
  • Test uses C_RESET1 and C_RESET2 sequences
-unassignedPASS
1/1
01-Sep-2026 11:40:12
-
-
execution tbd

TC_I2C_0001 · I2C_REG_RW

PASS1/1
owner unassignedexecution tbd
Last run01-Sep-2026 11:40:12
Silicon1.0
BoardVAAK001 RevA
Firmware commitunknown
Bugsnone
Filesreport · log

Test description

  • I2C register read/write validation is executed from firmware
  • Default register values are verified after reset
  • Pattern testing is performed on CR, SR, AR, DR, ISR, TSR
  • Random data write/read is performed on all registers
  • Byte, half-word, and word accesses are validated
  • Invalid address access is tested
  • Test uses C_RESET1 and C_RESET2 sequences

Pass / fail criteria

-

Hardware connection

  • The connections are made on the ATE board.
  • gpio_3 (logger) ==> J2(19) ==> USB-to-UART(TX) ==> PC

Features and configuration

Register Read Write

1 result

↑